Power-Sonic

Dispositivi Supportati

Device Type	Modbus TCP (Ethernet)	RS485	Curtailment
PS-PULSE-INV-6KW	❌	✅	❌
PS-PULSE-INV-8KW
PS-PULSE-INV-10KW
PS-PULSE-INV-12KW

Cablaggio

RS485

RS485 Wiring

• For correct RS485 wiring: Follow the guidelines for RS485 wiring.
• If the wiring shown in the table below is incorrect, please let us know.
• There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.

Device	MidTeq EMS model OM1	MidTeq EMS model IG8	RS485-USB converter	RS485-Ethernet converter
	RS485 A	RS485_POS	RS485 A	TX+
	RS485 B	RS485_NEG	RS485 B	TX-
	RS GND	GND	Not available	G

Configurazione

NOTE: RS485 Device Addresses

• You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
• Use lower addresses first (1, 2, ...) because the MidTeq EMS will find them faster!
• For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The MidTeq EMS will scan on those first.

1. Imposta la modalità di lavoro su Auto Consumo

2. Imposta l'Export Zero su Disabilita

3. Imposta il Controllo Remoto su Abilita

4. Imposta l'indirizzo RS485. La baudrate predefinita è 9600, se non, impostala su 9600.

5. Imposta la corrente di carica. Imposta la corrente di carica.

IMPORTANTE!

Per un 5KT impostala su 100 Per 10KT impostala su 160

6. Imposta AC Coupling su Abilita